French Pleat

Seema, Week 2, Make-up in Motion, 28/1/14

French pleat

Tools used

1.       Pin tail comb

2.       Tongs

3.       Cape

4.       Smoothing out brush

5.       Wig pins

6.       Hair spray

 

·         Creating Barrel curls with BRICK WORK

 

 

·         Once you have rolled the top of the hair start working from the sides so the shape is formed

·         When you get to the other side curl the tongs in to the other direction

·         The back section is going to go in an upwards direction

·         When you come to the front side sections curl the curls inwards and up

·         WORK IN CLEAN SECTIONS

·         Using a PIN TAIL comb back comb the hair from middle of length of hair, create your mess then push it down

·         Pack in the backcombing down to the route

·         Using the SMOOTHING OUT PADDLE BRUSH very LIGHTLY smooth out the backcombing

·         DO NOT DO THIS HEAVILY AS YOU WILL LOOSE ALL THE WORK YOU HAVE PUT IN TO BACKCOMBING HAIR

·         Pull hair to the left

·         Put WIG PINS in back of hair to hold side and back sections up, cross pins over each other to hold in place

·         Put hand in and roll hair around to the left

·         Pin in to cross grips once you have manipulated hair in to shape

·         WIG PIN hair into cross grips

·         Put on to hair then move out and push in to crossed pins

·         Hair will stay put when backcombed well

·         When you have backcombed hair use SMOOTHING OUT brush to smooth and shape

·         Hair stays out as you have used tongs

·         Keep back combing hair each time you come to a section

·         Brush round head and manipulate into shape

·         Stand back and see what you could do to perfect hair

·         DON’T smooth over strays etc. with hairspray while you are creating the hair

·         Wait until you have finished to do this

(PICTURES BELOW ARE SEEMAS WORK)